This tutorial was written by Chasunicorn
on August 10, 2013.
*Updated November 2025*
Supplies:
Tube by Bits N Bobs
Not seen her selling since PFD
Scrap Kit by JL Designs
This kit is unavailable but any kit should work
Mask of choice
Filters:
NONE
Drop Shadow:
Whatever you prefer
Canvas Size:
700x700
C&P Elements:
*Raster 1...MW and C&P paper 1 into selection
Apply Mask of choice...Merge Group
*Element 1...C&P as a new layer...RS 45%
Using your selection tool on a Circle setting...draw out a
circle selection above the frame...Keep selected
*Tube...C&P a close up of your tube above the frame...
RS by 75% and again by 85%...using the selected area
erase any areas that stick out toward the bottom of the frame.
*Element 13...C&P as a new layer...RS 45% and again at 75%...
Place at the bottom of the frame...Duplicate as many time you
want and arrange where you like...Adjust sizes to suit your own taste
*Element 12...C&P as a new layer...RS 45% and again at 75%...
Place at the bottom of the frame...Duplicate as many time you
want and arrange where you like...Adjust sizes to suit your own taste
*Element 41...C&P as a new layer...RS 45% 2xs...
Place at the bottom of the frame...Duplicate as many time you
want and arrange where you like...Adjust sizes to suit your own taste
*Element 2b...C&P as a new layer...RS 45% 2xs...
Place at the bottom of the frame...arrange where you like
*Element 9...C&P as a new layer...RS 45% 3xs...Place at the bottom of
the frame...Duplicate as many time you want and arrange where you like
*Element 42...C&P as a new layer...RS 45% and again at 75%...
Place at the bottom of the frame...Rotate to the right at 30 degrees
*Element 33...C&P as a new layer...RS 25%...Arrange where you like it
Add your name, Copyright info and Watermark
Re-Size your tag if you want to and you are done
.png)
No comments:
Post a Comment